Wet Tile Saw -7" (2003445) Due 11/2/2024

About:

A wet tile saw is a stationary saw that looks something like a small table saw, but it incorporates water that runs over the cutting platform, blade, and tiles.

The water on the wet tile saw allows the tile and blade to stay cool while the cutting happens. Since the blade has to do a lot of work to cut through something hard and dense, like tile, there is a lot of friction that occurs and without water, the blade will have a tendency to heat up quickly and begin to smoke!

This Unit:

Includes fence and angle tile adapter. Includes water tray

Operation:

Step 1

Set up the saw on a stable, level platform, such as a tile saw stand, at a height that’ll allow you to work without hunching over or reaching up. Work in an area with plenty of space and enough light to give you a clear view of the table or tray, the tile, and the saw blade. If necessary, use drop cloths to protect the work area.

Step 2

Fill the saw reservoir with clean water, making sure you don’t overfill it. Change the water frequently as you cut. Debris in the water can affect the quality of the cut. If the saw uses a pump to circulate the water, changing the water often will extend the pump’s life.

Step 3

Depending on the saw, you may be able to adjust the height of the blade in relation to the table surface or tray. Smaller saws have a fixed blade and table. If your saw has a movable tray, slide it past the blade. The slot in the tray should fit neatly around the blade.

Step 4

Use a square edge or straightedge to draw the cut lines. You can mark the top of the tile with a china marker. The water won’t wash the marks away, but you can wipe them off after cutting the tile. Mark all tiles in advance, so you don’t have to continually stop cutting to mark the next tile.

Step 5

Place the tile on the table or sliding tray so that the largest portion of the tile is between your hand and the blade. Press the tile firmly against the guide fence. If you’re cutting diagonally across the tile, position it securely in the angle guide. Adjust the guide so the cut line aligns with the blade. Pull the tile back from the blade.

Step 6

When you near the end of the cut, use a push stick or push guide to direct the last bit of tile past the blade.

Safety:

Wear eye protection, hearing protection and a dust mask/respirator when using a wet saw. Don’t wear loose clothing or items, such as jewelry, that could get caught in the blade. If you have long hair, tie it back.

Loan Notes: